- Features
- Specifications
- Documents
Warranty Length
- 15 Years Limited on Heat Exchanger in Residential, 6 Years Limited on Heat Exchanger in Commercial, 5 Years on all Parts
Features
- Field convertible from natural gas to propane
- Complies with SCAQMD rule 1146.2 and other air quality management districts with similar NOx emission requirements of 14 NG/J or 20 PPM
- Copper heat exchanger 25X better heat transfers than stainless steel thus stabilizing outgoing water temperature quicker and reducing pressure drop across the heat exchanger
- Built-in freeze protection
- Manual reset Hi-limit (up to 194 deg F)
- Overheat cut-off fuse
- Inlet and outlet thermistors for constant temperature monitoring
- Air fuel ratio rod
- Flame sensor
- Venting and combustion - 4 in Category III stainless steel
- Power vent or power direct vent
- Vertical or horizontal installation
- Indoor model - Built-in temperature controller and factory installed power cord
- Approved for installation from sea level to 10100 ft elevation
Standard Approvals
- AHRI Certified
- ANSI Z21.10.3
- IAPMO Listed
- NSF Approved
Videos
Commercial/Residential/Dual:
Commercial/Residential
Condensing/Non Condensing:
Non-Condensing
Energy Factor:
0.82
Flow Rate:
10 gpm
Fuel Type:
Natural Gas
Gas Connection:
3/4 in NPT
Heating Capacity:
199000 Btu/hr
Height:
28"
Ignition Type:
Electronic
Indoor/Outdoor:
Indoor
Pressure Rating:
15 to 150 psi
Ultra Low NOx:
Yes
Vent Size:
3 in, 4 in
Vent Type:
Direct/Power
Water Connection:
3/4 in NPT
Width:
12.375 in
Height:
28"


