Beacon-Morris® K-42
  1. pin-int

Beacon-Morris® K-42

Beacon-Morris® TWIN-FLO III® K-42 Hydronic Kickspace Heater, 115 VAC, 0.5 A, 1 to 3 gpm

  • Manufacturers: Mestek
  • Brand Name: Beacon-Morris®
  • TSCO Part: 400700
  • MPN: K-42
  • UPC: 700201000150
  • Min. Order Qty: 1
  • Qty. Interval: 1

TWIN-FLO III heaters are for use with forced hot water residential heating systems and consist of a copper tube, aluminum finned heating element, with an electric motor and blower of unique cross flow design. Their purpose is to deliver a comfortable stream of warmed air, at or near floor level, and their construction is extremely compact so minimum space is required for installation.

Beacon-Morris® TWIN-FLO III® Hydronic Kickspace Heater, 115 VAC, 0.5 A, 1 to 3 gpm, 12-1/4 in Width, 12-3/4 in D, 4 in Height, 1480 to 5240 Btu/hr

Amperage Rating      :      0.5 A
Depth      :      12-3/4 in
Flow Rate      :      1 to 3 gpm
Heat Capacity      :      1480 to 5240 Btu/hr
Height      :      4 in
Voltage Rating      :      115 VAC
Width      :      12-1/4 in
  • Kickspace heaters are the space-saving alternative to hot water baseboard
  • The type K heater is primarily used in horizontal floor installation, for example under a kitchen counter cabinet, or bathroom sink enclosure
  • They are ideal for radiant systems with the use of a low temperature aquastat designed to turn the unit on at 110 deg F
  • Type W is for vertical mounting, fully recessed in the wall studs, with the air discharged upward through a flush mounted, louvered front panel
  • Type F is a surface mounted wall unit, with the air discharged evenly through a louvered front panel in an upward direction
  • All types have heating elements with 1/2 in nominal (5/8 in O.D) copper tube connections and 115 V
  • Electric blower motor, interwired with a 120 deg F (49 deg C) reverse acting aquastat that prevents operation until hot water is circulating
  • These units are NOT intended to be used on one or two pipe steam systems
  • For gravity fed systems, it is recommended that a separate circulator pump be installed for the kickspace heater
  • Designed to fit inconspicuously under a cabinet, in the floor, on or in the wall
  • Hot water from the home's boiler is circulated through the kickspace unit and the fan gently blows heated air into the room
  • The homeowner simply selects the fan speed, then the unit turns on and off automatically according to heating demand
  • 53 cfm high speed
  • 3200 rpm
  • 0.034 hp motor
  • 30.7 watt
  • pdfSpecification Sheet